STEERING COLUMN ASSEMBLY > REMOVAL |
| 1. PRECAUTION |
| 2. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD |
| 3. REMOVE FRONT WHEEL LH |
| 4. REMOVE HORN BUTTON ASSEMBLY |
| 5. REMOVE STEERING WHEEL ASSEMBLY (for 3 Spoke) |
![]() |
Remove the steering wheel assembly set nut.
| *a | Matchmark |
Put matchmarks on the steering wheel assembly and steering main shaft.
Disconnect the connectors from the spiral cable sub-assembly and steering wheel assembly.
![]() |
Using SST, remove the steering wheel assembly.
| *a | Turn |
| *b | Hold |
| 6. REMOVE STEERING WHEEL ASSEMBLY (for 4 Spoke) |
![]() |
Remove the steering wheel assembly set nut.
| *a | Matchmark |
Put matchmarks on the steering wheel assembly and steering main shaft.
Disconnect the connectors from the spiral cable sub-assembly.
![]() |
Using SST, remove the steering wheel assembly.
| *a | Turn |
| *b | Hold |
| 7. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
| 8. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Remove the 2 screws.
![]() |
Push the right and left sides of the lower steering column cover, and disengage the 2 claws.
![]() |
Insert a finger into the opening of the tilt lever of the lower steering column cover to disengage the claw and remove the lower steering column cover.
| 9. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Disengage the 4 clips and 2 guides from the upper steering column cover.
![]() |
Disengage the 2 claws to remove the upper steering column cover.
| 10. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY |
Disconnect the connectors from the turn signal switch assembly with spiral cable sub-assembly.
![]() |
Disengage the 3 claws to remove the turn signal switch assembly with spiral cable sub-assembly from the steering post assembly.
| 11. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Using a screwdriver, loosen the clamp as shown in the illustration.
![]() |
Put matchmarks on the steering intermediate shaft assembly and the steering link assembly.
| *a | Matchmark |
Remove the bolt and separate the steering intermediate shaft assembly from the steering link assembly.
| 12. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY |
![]() |
Disengage the 2 claws and guide to remove the No. 2 air duct sub-assembly.
| 13. REMOVE STEERING POST ASSEMBLY |
Disconnect the connectors and disengage the wire harness clamps from the steering post assembly.
![]() |
Disconnect the 2 connectors.
![]() |
Disengage the clamp.
![]() |
Remove the bolt to separate the ground wire.
Remove the 4 nuts and the steering post assembly.
| 14. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Remove the bolt and slide the steering intermediate shaft assembly.
| *a | Matchmark |
Put matchmarks on the steering intermediate shaft assembly and the steering post assembly.
Remove the steering intermediate shaft assembly from the steering column assembly.