FRONT DOOR > ADJUSTMENT |

| *1 | Centering Bolt |
| *2 | Standard Bolt |
| 1. INSPECT FRONT DOOR |
Check that the clearance measurements of areas a through p are within each standard range.

| Area | Measurement | Area | Measurement |
| a | 3.35 to 6.35 mm (0.132 to 0.250 in.) | b | 9.0 to 12.0 mm (0.354 to 0.472 in.) |
| c | 3.35 to 6.35 mm (0.132 to 0.250 in.) | d | 1.7 to 4.7 mm (0.0669 to 0.185 in.) |
| e | 3.35 to 6.35 mm (0.132 to 0.250 in.) | f | 1.0 to 4.0 mm (0.0394 to 0.157 in.) |
| g | 2.3 to 6.3 mm (0.0906 to 0.248 in.) | h | 2.96 to 4.64 mm (0.115 to 0.182 in.) |
| i | -0.84 to 0.84 mm (-0.0331 to 0.0331 in.) | j | 2.96 to 4.64 mm (0.115 to 0.182 in.) |
| k | -0.84 to 0.84 mm (-0.0331 to 0.0331 in.) | l | 2.9 to 7.1 mm (0.114 to 0.280 in.) |
| m | 2.3 to 4.7 mm (0.0906 to 0.185 in.) | n | -1.2 to 1.2 mm (-0.0472 to 0.0472 in.) |
| o | 2.3 to 4.7 mm (0.0906 to 0.185 in.) | p | -1.2 to 1.2 mm (-0.0472 to 0.0472 in.) |
| 2. REMOVE FRONT WHEEL |
| 3. REMOVE FRONT WHEEL OPENING EXTENSION PAD |
| 4. REMOVE FRONT FENDER LINER |
| 5. REMOVE FRONT FENDER SEAL |
![]() |
Disengage the 3 clips and remove the front fender seal.
| 6. ADJUST FRONT DOOR |
![]() |
Using SST, loosen the hinge bolts on the vehicle body and adjust the door position.
Tighten the hinge bolts on the vehicle body after adjustment.
Loosen the hinge bolts on the door and adjust the door position.
Tighten the hinge bolts on the door after adjustment.
![]() |
Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.
Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.
| 7. INSTALL FRONT FENDER SEAL |
![]() |
Install the front fender seal with new 3 clips.
| 8. INSTALL FRONT FENDER LINER |
| 9. INSTALL FRONT WHEEL OPENING EXTENSION PAD |
| 10. INSTALL FRONT WHEEL |