REAR DOOR > ADJUSTMENT |

| *1 | Centering Bolt |
| *2 | Standard Bolt |
| 1. INSPECT REAR DOOR |
Check that the clearance measurements of areas a through r are within each standard range.

| Area | Measurement | Area | Measurement |
| a | 3.35 to 6.35 mm (0.132 to 0.250 in.) | b | 0.6 to 3.6 mm (0.0236 to 0.142 in.) |
| c | 3.35 to 6.35 mm (0.132 to 0.250 in.) | d | 0.9 to 3.9 mm (0.0354 to 0.154 in.) |
| e | 3.35 to 6.35 mm (0.132 to 0.250 in.) | f | 1.5 to 4.5 mm (0.0591 to 0.177 in.) |
| g | 3.35 to 6.35 mm (0.132 to 0.250 in.) | h | 5.4 to 8.4 mm (0.213 to 0.331 in.) |
| i | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) | j | 2.0 to 5.0 mm (0.0787 to 0.197 in.) |
| k | 2.0 to 5.0 mm (0.0787 to 0.197 in.) | l | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| m | 2.9 to 7.1 mm (0.114 to 0.280 in.) | n | 2.96 to 4.64 mm (0.115 to 0.182 in.) |
| o | -0.84 to 0.84 mm (-0.0331 to 0.0331 in.) | p | 2.96 to 4.64 mm (0.115 to 0.182 in.) |
| q | -0.84 to 0.84 mm (-0.0331 to 0.0331 in.) | r | 2.3 to 6.3 mm (0.0906 to 0.248 in.) |
| 2. ADJUST REAR DOOR |
![]() |
Using SST, loosen the hinge bolts on the vehicle body and adjust the door position.
Tighten the hinge bolts on the vehicle body after the adjustment.
Loosen the hinge bolts on the door and adjust the door position.
Tighten the hinge bolts on the door after the adjustment.
![]() |
Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.
Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.