Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR

LUGGAGE COMPARTMENT DOOR > ADJUSTMENT

for Preparation Click here


B280558E01
Text in Illustration 
*1
Centering Bolt
*2
Standard Bolt

HINT:
  1. Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
  2. Specified torque for standard bolts is shown in the standard bolt chart (Click here).



1. REMOVE LUGGAGE COMPARTMENT DOOR COVER


    B280555
  1. Remove the 13 clips and luggage compartment door cover.



2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
  1. Remove the luggage compartment floor mat.



3. REMOVE BAGGAGE HOLDER NET (w/ Partition Net)
  1. Remove the baggage holder net.



4. REMOVE REAR FLOOR FINISH PLATE


    B280564
  1. Remove the 5 clips.



    B280565
  1. Disengage the 4 clips and remove the rear floor finish plate.



5. ADJUST LUGGAGE COMPARTMENT DOOR


    B280559
  1. Loosen the door side hinge bolts to adjust the door horizontally and vertically.

    Torque:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }



    B280560
  1. Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.

  1. Using a brass bar and a hammer, hit the striker to adjust its position.

  1. Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }



6. INSTALL REAR FLOOR FINISH PLATE


    B280636
  1. Engage the 4 clips and install the rear floor finish plate.

  1. Install the 5 clips.



7. INSTALL BAGGAGE HOLDER NET (w/ Partition Net)
  1. Install the baggage holder net.



8. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
  1. Install the luggage compartment floor mat.



9. INSTALL LUGGAGE COMPARTMENT DOOR COVER


    B280555
  1. Install the luggage compartment door cover with the 13 clips.



10. INSPECT LUGGAGE COMPARTMENT DOOR


  1. Check that the clearance measurements of areas a through d are within each standard range.


    B277179E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    a
    6.4 mm (0.252 in.)
    b
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    c
    -1.0 to 2.0 mm (-0.0394 to 0.0787 in.)
    d
    3.85 to 7.85 mm (0.152 to 0.309 in.)