Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > INITIALIZATION

for Preparation Click here



MAINTENANCE REQUIRED REMINDER RESET PROCEDURE

HINT:
The ODO/TRIP change switch knob is located on the light side of the combination meter assembly.

  1. Turn the ignition switch to ON.

  2. Press the ODO/TRIP change switch knob until the TRIP A meter appears.

  3. Turn the ignition switch off.

  4. Turn the ignition switch to ON while pressing and holding the ODO/TRIP change switch knob. Hold the ODO/TRIP change switch knob until the following conditions are met and 5 seconds have elapsed.

  5. w/o Multi-information Display:

    1. The TRIP A meter shows "000000".

    2. The maintenance required reminder light goes off.

  6. w/ Multi-information Display:

    1. The TRIP A meter shows "000000".

    2. The multi-information display shows that the reset is complete.