Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (for Built-in Type Yaw Rate Sensor)

AIRBAG SYSTEM (for Built-in Type Yaw Rate Sensor) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the airbag system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CHECK YAW RATE SENSOR LOCATION*
    1. Using the Techstream, check if the yaw rate sensor is connected to the CAN communication system (Click here).

      Result:
      Result
      Proceed to
      The yaw rate sensor is not connected to the CAN communication system.
      A
      The yaw rate sensor is connected to the CAN communication system.
      B



    B.
    GO TO AIRBAG SYSTEM (for Separate Type Yaw Rate Sensor) (Click here)
    A


    3.CUSTOMER PROBLEM ANALYSIS
    1. Confirm problem symptoms (Click here).


    NEXT


    4.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally.

      HINT:
      1. Refer to Bus Check for the CAN communication system (Click here).
      2. The airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

      Result:
      Result
      Proceed to
      CAN communication DTC is not output.
      A
      CAN communication DTC is output.
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.SRS WARNING LIGHT CHECK
    1. Proceed to Diagnosis System (Click here).


    NEXT


    6.CHECK FOR DTC*
    1. Proceed to DTC Check / Clear (Click here).

      Result:
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B



    B.
    Go to step 8
    A


    7.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).


    NEXT

    Go to step 10


    8.SYMPTOM SIMULATION
    1. Proceed to How to Proceed with Troubleshooting (Click here).


    NEXT


    9.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).


    NEXT


    10.CIRCUIT INSPECTION*

      NEXT


      11.IDENTIFICATION OF PROBLEM

        NEXT


        12.REPAIR OR REPLACEMENT

          NEXT


          13.CONFIRMATION TEST

            NEXT

            END