Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1432    Steering Angle Sensor Power Source Voltage Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when the skid control ECU receives a +B line open signal from the steering angle sensor.

DTC No.
DTC Detection Condition
Trouble Area
C1432
With the +BS terminal voltage 9.6 to 16.5 V, the steering angle sensor power supply circuit malfunction signal is received from the steering angle sensor.
  1. Steering angle sensor power supply
  2. Steering angle sensor

WIRING DIAGRAM

Refer to DTC C1434 .

INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)


    C156493E40
  1. Remove the steering wheel and the column cover.

  1. Make sure that there is no looseness at the locking part and the connecting part of the connector.

  1. Disconnect the steering angle sensor connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I29-5 (BAT) - Body ground
    Always
    11 to 14 V
    I29-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Steering Angle Sensor)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK


2.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)


    C156493E41
  1. Turn the ignition switch off.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I29-1 (ESS) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Steering Angle Sensor)

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK

REPLACE STEERING ANGLE SENSOR (Click here)