TIRE PRESSURE WARNING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer to confirm the trouble.
| |||||
| 3.ADJUST TIRE PRESSURE* |
Turn the ignition switch off.
Set the all tire pressure to the specified value .
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Read the "ID Tire Inflation Pressure" values.
Check the Data List (Click here).
| Condition | Proceed to |
| Tire pressure warning light remains on | A |
| Tire pressure warning light goes off | B |
|
| ||||
| |||||
| 4.CHECK ECU CONNECTED TO CAN BUS* |
Check the ECUs connected to the CAN bus (Click here).
| Result | Proceed to |
| No malfunction appears | A |
| Malfunction appears | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)* |
Check for DTCs (Click here).
| Result | Proceed to |
| CAN system DTC is not output | A |
| CAN system DTC is output | B |
|
| ||||
| |||||
| 6.CHECK FOR DTC* |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| |||||
| 7.DTC CHART |
Refer to Diagnostic Trouble Code Chart (Click here).
|
| ||||
|---|---|---|---|---|---|
| 8.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| |||||
| 9.CIRCUIT INSPECTION* |
Refer to Electronic Circuit Inspection Procedure (Click here).
| |||||
| 10.REPAIR OR REPLACE |
Repair or replace parts based on the diagnosis result.
| |||||
| 11.CONFIRMATION TEST* |
Check the Data List to confirm that the tire inflation pressure has been received (Click here).
Perform initialization (Click here).
Confirm that the initialization has been completed.
|
| ||||
|---|---|---|---|---|---|