Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TIRE PRESSURE WARNING ECU AND RECEIVER

HINT:
Inspect the connectors from the back side while the connectors are connected.


E129452E51


Text in Illustration 
*A
w/ Wireless Door Lock Control System
*B
w/o Wireless Door Lock Control System
  1. Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    O25-1 (IG) - O25-12 (GND)*1
    O33-1 (IG) - O33-12 (GND)*2
    V - BR
    IG power source
    Ignition switch ON
    10 to 16 V
    O25-3 (CLSW) - O25-12 (GND)*1
    O33-3 (CLSW) - O33-12 (GND)*2
    Y - BR
    Tire pressure warning reset switch
    1. Ignition switch ON
    2. Tire pressure warning reset switch ON
    Below 1.5 V
    1. Ignition switch ON
    2. Tire pressure warning reset switch OFF
    8 to 15 V
    O25-4 (RDA) - O25-12 (GND)*1
    O33-4 (RDA) - O33-12 (GND)*2
    V - BR
    Output signals
    Ignition switch ON
    Pulse generation (see waveform 1)
    O25-5 (PRG) - O25-12 (GND)*1
    O33-5 (PRG) - O33-12 (GND)*2
    L - BR
    Input signals
    Ignition switch ON
    Pulse generation (see waveform 1)
    O25-12 (GND) - Body ground*1
    O33-12 (GND) - Body ground*2
    BR - Body ground
    Ground
    Always
    Below 1 Ω

    1. *1: w/ Wireless Door Lock Control System
    2. *2: w/o Wireless Door Lock Control System



  2. C240058E01
  3. Using an oscilloscope, check waveform 1.
    Text in Illustration 
    *a
    Example
    *b
    GND
    Waveform 1: 
    Item
    Contents
    Terminal
    O25-4 (RDA) - O25-12 (GND)*1
    O33-4 (RDA) - O33-12 (GND)*2
    O25-5 (PRG) - O25-12 (GND)*1
    O33-5 (PRG) - O33-12 (GND)*2
    Tool setting
    5 V/DIV, 50 μs./DIV.
    Vehicle condition
    Ignition switch ON

    1. *1: w/ Wireless Door Lock Control System
    2. *2: w/o Wireless Door Lock Control System

    HINT:
    The waveform shown in the illustration is an example. If the tester displays a waveform that alternates between high and low, where high is a voltage that is between the IG power source voltage and a voltage 2.2 V lower than the IG power source voltage, and where low is a voltage of between 0 and 1.2 V, the ECU can be judged normal.