Home › Engine / Hybrid System · 2GR-FE › COOLING › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FAN RELAY


    A260082
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Apply battery voltage between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.