Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
  1. Pass the hood lock control cable assembly into the engine compartment.

  1. Pass the cable through the upper radiator support.

  1. Engage the hood cable grommet.

  1. Engage the 5 clamps and install the hood lock control cable assembly.



2. INSTALL HOOD LOCK ASSEMBLY


    B277171
  1. Apply MP grease to the sliding areas of the lock.

  1. Connect the hood lock control cable assembly.

  1. Install the hood lock assembly with the 3 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. w/ Engine Hood Courtesy Switch:

    1. Connect the connector.



3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
  1. Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.



4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
  1. Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.



5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
  1. Engage the 2 clips.

  1. Install the cowl side trim sub-assembly LH with the clip.



6. INSTALL FRONT DOOR SCUFF PLATE LH
  1. Engage the 10 claws to install the front door scuff plate LH.



7. INSTALL FRONT FENDER LINER LH

HINT:
Use the same procedure for the RH side and LH side .



8. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

HINT:
Use the same procedure for the RH side and LH side .



9. INSTALL FRONT WHEEL LH

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }



10. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
(Click here)


11. ADJUST HOOD SUB-ASSEMBLY
(Click here)