Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
(Click here)


2. REMOVE FRONT WHEEL LH


3. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

HINT:
Use the same procedure for the RH side and LH side .



4. REMOVE FRONT FENDER LINER LH

HINT:
Use the same procedure for the RH side and LH side .



5. REMOVE FRONT DOOR SCUFF PLATE LH


    B278977
  1. Disengage the 10 claws and remove the front door scuff plate LH.



6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B278978
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.



7. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B279865
  1. Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.



8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B277166
  1. Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.



9. REMOVE HOOD LOCK ASSEMBLY


  1. w/ Engine Hood Courtesy Switch:



      B277167
    1. Disconnect the connector.



    B277168
  1. Remove the 3 bolts.



    B277169
  1. Disconnect the hood lock control cable assembly and remove the hood lock assembly.



10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Using a screwdriver, disengage 5 clamps and hood cable grommet as shown in the illustration.


    B277170E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Hood Cable Grommet
    *3
    Washer Hose
    *4
    Hood Lock Control Cable Clamp

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the hood lock control cable assembly from the engine compartment and remove it.