STARTER > INSPECTION |
| 1. INSPECT STARTER ASSEMBLY |
Perform a pull-in test.
Remove the nut and disconnect the lead wire from terminal C.
![]() |
Connect the battery to the magnetic switch as shown in the illustration. Check that the clutch pinion gear extends.
| *1 | Terminal 50 |
| *2 | Terminal C |
![]() |
Perform a hold-in test.
While maintaining the battery connections of the pull-in test above, disconnect the negative (-) lead from terminal C. Check that the pinion gear remains extended.
| *1 | Terminal C |
| *a | Disconnect |
![]() |
Perform a clutch pinion gear return test.
Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns.
If the clutch pinion gear does not return, replace the magnetic switch assembly.
| *a | Disconnect |
![]() |
Perform a no-load performance test.
| *1 | Terminal 30 |
| *2 | Terminal 50 |
Connect the lead wire to terminal C with the nut. Make sure that the lead is not grounded.
Clamp the starter in a vise.
Connect the battery and an ammeter to the starter as shown in the illustration.
Check that the starter rotates smoothly and steadily while the pinion gear is moving out. Then measure the current.
| 2. INSPECT REPAIR SERVICE STARTER KIT |
![]() |
Check the plunger.
Push in the plunger and check that it returns quickly to its original position.
If necessary, replace the repair service starter kit.
![]() |
Check if the pull-in coil has an open circuit.
| *1 | Terminal C |
| *2 | Terminal 50 |
Measure the resistance between terminals 50 and C.
![]() |
Check if the hold-in coil has an open circuit.
| *1 | Terminal 50 |
| *2 | Body |
Measure the resistance between terminal 50 and the switch body.
| 3. INSPECT STARTER ARMATURE ASSEMBLY |
Check the commutator for contamination and burns on its surface.
If the surface is dirty or burnt, correct it with sandpaper (No. 400) or a lathe.
![]() |
Check if the commutator has an open circuit.
| *1 | Segment |
Measure the resistance between the segments of the commutator.
![]() |
Check if the commutator is grounded.
| *1 | Commutator |
| *2 | Coil Core |
Measure the resistance between the commutator and armature coil core.
![]() |
Using a vernier caliper, measure the commutator length.
| *a | Length |
| 4. INSPECT STARTER COMMUTATOR END FRAME ASSEMBLY |
![]() |
Using a vernier caliper, measure the brush length.
| *a | Length |
![]() |
Check the brush insulation.
Measure the resistance between the positive (+) and negative (-) brushes.
| 5. INSPECT STARTER CLUTCH |
![]() |
Rotate the clutch pinion gear counterclockwise and check that it turns freely. Try to rotate the clutch pinion gear clockwise and check that it locks.
| *a | Lock |
| *b | Free |