STARTER > REASSEMBLY |
| 1. INSTALL PLANETARY GEAR |
![]() |
Apply grease to the planetary gears and pin parts of the planetary shaft.
![]() | High-temperature grease |
Install the 3 planetary gears.
| 2. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Apply grease to the armature shaft.
![]() | High-temperature grease |
![]() |
Apply high-temperature grease to the plate washer and bearing, as shown in the illustration.
![]() | High-temperature grease |
Install the starter armature to the starter commutator end frame.
![]() |
Using snap ring pliers, install the plate washer and a new snap ring.
| *a | Snap Ring Pliers |
![]() |
Using a vernier caliper, measure the length of the snap ring.
| *a | Length |
| 3. INSTALL STARTER COMMUTATOR END FRAME COVER |
![]() |
Install the end frame cover to the commutator end frame.
| 4. INSTALL STARTER ARMATURE PLATE |
![]() |
Insert the starter armature plate to the starter yoke.
| *a | Keyway |
| *b | Key |
Align the keyway of the starter armature plate with the key inside the starter yoke, and install the starter armature plate.
| 5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY |
![]() |
Align the rubber of the end frame with the cutout of the starter yoke.
| *a | Cutout |
| *b | Rubber |
Install the end frame to the starter yoke.
| 6. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Align the protrusion of the starter yoke with the cutout of the starter drive housing.
| *a | Cutout |
| *b | Protrusion |
![]() |
Install the starter yoke with the 2 through-bolts.
| 7. INSTALL REPAIR SERVICE STARTER KIT |
![]() |
Apply grease to the plunger and the hook.
![]() | High-temperature grease |
Hang the plunger hook of the magnetic switch to the drive lever.
Install the plunger and return spring.
![]() |
Install the magnetic switch with the 2 screws.
![]() |
Connect the lead wire to the magnetic switch with the nut.