TORQUE CONVERTER AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER ASSEMBLY |
Inspect the one-way clutch.
![]() |
Press on the splines of the stator with a finger and rotate the stator. Check that the stator rotates smoothly when turned clockwise and rotates with difficulty when turned counterclockwise.
If necessary, clean the torque converter and recheck the one-way clutch.
Replace the torque converter if the one-way clutch still fails the inspection.
![]() | Difficult |
![]() | Smooth |
![]() |
Inspect the torque converter assembly.
If any of the following problems are present, replace the torque converter assembly.
| *a | Sample showing maximum allowable amount of powder in ATF |
Replace the ATF in the torque converter.
![]() |
Clean and check the oil cooler and oil pipe line.
![]() |
Prevent deformation of the torque converter and damage to the oil pump gear.
| *a | Correct |
| *b | Incorrect |
| *c | Bottom is damaged |
| 2. INSPECT DRIVE PLATE |
Check the drive plate for damage.
![]() |
Set up a dial indicator and measure the runout at the 6 areas on the drive plate surface that contact the torque converter.
![]() | Measuring Point |