DTC C2177/77 Initialization not Completed |
| DTC No. | DTC Detection Condition | Trouble Area |
| C2177/77 |
|
|

| 1.CHECK FREQUENCY RECEIVING CONDITION |
Check that the vehicle is not located in an area such as described below:
Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.
Devices using similar radio frequencies are used in the vehicle.
|
| ||||
| OK | |
| 2.PERFORM INITIALIZATION |
Perform initialization (Click here).
| NEXT | |
| 3.CONFIRM TIRE INFLATION PRESSURE (DATA LIST) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| ID1 Tire Inflation Pressure | ID1 tire inflation pressure/ min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) | Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID2 Tire Inflation Pressure | ID2 tire inflation pressure / min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) | Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID3 Tire Inflation Pressure | ID3 tire inflation pressure / min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) | Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| ID4 Tire Inflation Pressure | ID4 tire inflation pressure / min.: Absolute pressure / 50 kPa (0.5 kgf/cm2, 7 psi), Relative pressure / -50 kPa (-0.5 kgf/cm2, -7 psi) max.: Absolute pressure / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure / 380 kPa (3.9 kgf/cm2, 55 psi) | Actual tire inflation pressure | If 50 kPa (0.5 kgf/cm2, 7 psi) is displayed for absolute pressure or -50 kPa (-0.5 kgf/cm2, -7 psi) is displayed for relative pressure, data has not been received.* |
| Result | Proceed to |
| All tire pressure readings are equal to specified values. | A |
| Tire pressure values are not displayed. | B |
|
| ||||
| A | ||
| ||