OCCUPANT CLASSIFICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CHECK YAW RATE SENSOR LOCATION* |
Using the Techstream, check if the yaw rate sensor is connected to the CAN communication system (Click here).
| Result | Yaw Rate Sensor Type |
| The yaw rate sensor is connected to the CAN communication system. | Separate Type Yaw Rate Sensor |
| The yaw rate sensor is not connected to the CAN communication system. | Built-in Type Yaw Rate Sensor |
| |||||
| 3.CUSTOMER PROBLEM ANALYSIS |
Confirm problem symptoms (Click here).
| |||||
| 4.PASSENGER AIRBAG ON/OFF INDICATOR CHECK |
Proceed to Diagnosis System (Click here).
| |||||
| 5.DTC CHECK (Present and History DTCs)* |
Proceed to DTC Check / Clear (Click here).
| Result | Proceed to |
| DTC is output. | A |
| DTC is not output. | B |
|
| ||||
| |||||
| 6.DTC CHART |
Proceed to Diagnostic Trouble Code Chart (Click here).
| |||||
| 7.CIRCUIT INSPECTION* |
| |||||
| 8.REPAIR |
| |||||
| 9.CLEAR DTCS (Present and History DTCs)* |
Proceed to DTC Check / Clear (Click here).
| |||||
| 10.DTC CHECK* |
Proceed to DTC Check / Clear (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| |||||
| 11.SYMPTOM SIMULATION |
Check the passenger airbag ON/OFF indicator condition.
| Result | Proceed to |
| Passenger airbag ON/OFF indicator operates normally. | A |
| Passenger airbag ON/OFF indicator ("OFF") and SRS warning light come on. | B |
|
| ||||
| |||||
| 12.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|