Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY


    C149517E01
  1. Position the front shock absorber assembly level with the piston rod fully extended. Using a drill, make a hole in the cylinder between A and B as shown in the illustration to discharge the gas inside.

    CAUTION:
    Always use proper safety equipment and be careful when drilling because shards of metal may fly about.

    HINT:
    The gas is colorless, odorless and non-poisonous.