Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. LOOSEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    C238965
  1. Loosen the front support to front shock absorber nut.

    NOTICE:
    1. Do not remove the front support to front shock absorber nut.
    2. Loosen the front support to front shock absorber nut only when the front shock absorber with coil spring needs to be disassembled.



3. SEPARATE FRONT SPEED SENSOR


    C238961
  1. Remove the bolt and clamp, and separate the front speed sensor and front flexible hose from the front shock absorber assembly.

    NOTICE:
    Be sure to separate the front speed sensor from the front shock absorber assembly completely.



4. SEPARATE FRONT STABILIZER LINK ASSEMBLY


    C239296
  1. Remove the nut and separate the front stabilizer link assembly from the front shock absorber assembly.
    If the ball joint turns together with the nut, use a hexagon wrench to hold the stud bolt.



5. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    C238983E01
  1. Support the front axle using a jack and wooden block.
    Text in Illustration 
    *1
    Jack
    *2
    Wooden Block
    V100135
    Front of the Vehicle



    C132414
  1. Remove the 2 bolts and 2 nuts, and separate the front shock absorber with coil spring (lower side) from the steering knuckle.

    NOTICE:
    When removing the nuts, keep the bolts from rotating.



    C238964
  1. Remove the 3 nuts and front shock absorber with coil spring.

    NOTICE:
    Make sure that the front speed sensor is completely separated from the front shock absorber with coil spring.



6. SECURE FRONT SHOCK ABSORBER WITH COIL SPRING


    C135501E04
  1. Install SST to the front coil spring with the hooks spread as far apart as possible from each other.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    Make sure that the claws on the hooks are securely engaged to the spring.



    C166280E03
  1. Install the bolt and nut to the front shock absorber assembly as shown in the illustration and secure the front shock absorber assembly in a vise using aluminum plates.

    Standard length A:
    28 mm (1.10 in.)



7. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    C166281E01
  1. Using SST, compress the front coil spring.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    Do not use an impact wrench. It will damage SST.

    If the front coil spring is compressed at an angle, using 2 SST will make the work easier.

  1. Check that the front coil spring is sufficiently compressed.



    C149544
  1. Remove the front support to front shock absorber nut.



8. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY


9. REMOVE FRONT SUSPENSION SUPPORT BEARING


10. REMOVE FRONT UPPER COIL SPRING SEAT


11. REMOVE FRONT UPPER COIL SPRING INSULATOR


12. REMOVE FRONT COIL SPRING


13. REMOVE FRONT SPRING BUMPER


14. REMOVE FRONT LOWER COIL SPRING INSULATOR


15. REMOVE FRONT SHOCK ABSORBER ASSEMBLY