Home › Suspension › REAR SUSPENSION › REAR STRUT ROD

REAR STRUT ROD > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY


    C132496
  1. Temporarily tighten rear strut rod assembly (rear side) with the bolt and nut.

    NOTICE:
    When temporarily tightening the bolt, keep the nut from rotating.

    HINT:
    Insert the bolt from the inside of the vehicle.

  1. Support the rear axle carrier sub-assembly with a jack and a wooden block.

  1. Connect the rear strut rod assembly (front side) with the 2 bolts.



2. STABILIZE SUSPENSION


    C239098E01
  1. Jack up the rear axle carrier sub-assembly, placing a wooden block under it to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm assembly (inner side) is horizontally aligned with the center of the rear axle hub.
    Text in Illustration 
    *1
    Wooden Block

    CAUTION:
    Do not jack up the rear axle carrier sub-assembly too high as the vehicle may fall.

    NOTICE:
    1. When jacking up the rear axle carrier sub-assembly, be sure to jack it up slowly.
    2. Make sure to perform this operation with the vehicle kept as low as possible.



3. FULLY TIGHTEN REAR STRUT ROD ASSEMBLY
  1. Fully tighten the bolt (rear side).

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

    NOTICE:
    Since a stopper nut is used, fully tighten the bolt.

  1. Fully tighten the 2 bolts (front side).

    Torque:
    85 N*m{ 867 kgf*cm , 63 ft.*lbf }



4. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
  1. Connect the No. 3 parking brake cable assembly with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



5. INSTALL REAR WHEEL

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }