Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the occupant detection ECU.



1. INSPECT OCCUPANT DETECTION ECU (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check (Click here).



2. INSPECT OCCUPANT DETECTION ECU (for Vehicle Involved in Collision and Airbag not Deployed)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the occupant detection ECU.

    1. The defects are as follows:

      1. Cracks on the ECU housing
      2. Dents on the ECU housing
      3. Chips on the ECU housing
      4. Cracks or other damage to the connector
      5. Damage to the serial number

      OK:
      No defects are found.

      If any of the defects is found, replace the occupant detection ECU with a new one.



3. INSPECT OCCUPANT DETECTION ECU (for Vehicle Involved in Collision and Airbag is Deployed)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the occupant detection ECU.

    1. The defects are as follows:

      1. Cracks on the ECU housing
      2. Dents on the ECU housing
      3. Chips on the ECU housing
      4. Cracks or other damage to the connector
      5. Damage to the serial number

      OK:
      No defects are found.

      If any of the defects is found, replace the occupant detection ECU with a new one.