DTC B2416 Height Control Sensor Malfunction |
| DTC No. | DTC Detecting Condition | Trouble Area |
| B2416 |
|
|

| 1.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / HL Auto Leveling / Data List.
Read the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Height Sens Pw Supply Val | Height control sensor power supply value / 0.00 to 5.00 V | Approx. 5 V | - |
|
| ||||
| OK | ||
| ||
| 3.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY |
Remove the rear height control sensor sub-assembly (Click here).
Inspect the rear height control sensor sub-assembly (Click here).
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - HEIGHT CONTROL SENSOR) |
Disconnect the A34 headlight leveling ECU assembly connector.
Disconnect the O17 rear height control sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A34-12 (SBR) - O17-3 (SHB) | Always | Below 1 Ω |
| A34-19 (SHRL) - O17-2 (SHRR) | Always | Below 1 Ω |
| A34-21 (SGR) - O17-1 (SHG) | Always | Below 1 Ω |
| A34-12 (SBR) - Body ground | Always | 10 kΩ or higher |
| A34-19 (SHRL) - Body ground | Always | 10 kΩ or higher |
| A34-21 (SGR) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||