AUDIO AND VISUAL SYSTEM (for Radio and Display Type without Intuitive Parking Assist System) > Speaker Circuit |
| for 6 Speakers |

| for 10 Speakers |


| 1.CONFIRM MODEL |
| Result | Proceed to |
| for 6 Speakers | A |
| for 10 Speakers | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR |
Disconnect the connectors from the radio and display receiver assembly and speakers.
Measure the resistance between each of the front No. 2 speaker assemblies and the radio and display receiver assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I152-1 (FR+) - I83-4 (TWR+) | Always | Below 1 Ω |
| I152-5 (FR-) - I83-2 (TWR-) | Always | Below 1 Ω |
| I152-2 (FL+) - I1-4 (TWL+) | Always | Below 1 Ω |
| I152-6 (FL-) - I1-2 (TWL-) | Always | Below 1 Ω |
Measure the resistance between each of the front No. 1 speaker assemblies and the front No. 2 speaker assemblies to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I83-3 (+) - J5-1 | Always | Below 1 Ω |
| I83-1 (-) - J5-2 | Always | Below 1 Ω |
| I1-3 (+) - K5-1 | Always | Below 1 Ω |
| I1-1 (-) - K5-2 | Always | Below 1 Ω |
Measure the resistance between each of the rear speaker assemblies and the radio and display receiver assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I153-1 (RR+) - O18-1 | Always | Below 1 Ω |
| I153-3 (RR-) - O18-2 | Always | Below 1 Ω |
| I153-2 (RL+) - O21-1 | Always | Below 1 Ω |
| I153-6 (RL-) - O21-2 | Always | Below 1 Ω |
Measure the resistance between the radio and display receiver assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I152-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| I152-5 (FR-) - Body ground | Always | 10 kΩ or higher |
| I152-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| I152-6 (FL-) - Body ground | Always | 10 kΩ or higher |
| I153-1 (RR+) - Body ground | Always | 10 kΩ or higher |
| I153-3 (RR-) - Body ground | Always | 10 kΩ or higher |
| I153-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| I153-6 (RL-) - Body ground | Always | 10 kΩ or higher |
Measure the resistance between each of the front No. 2 speaker assemblies and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I83-3 (+) - Body ground | Always | 10 kΩ or higher |
| I83-1 (-) - Body ground | Always | 10 kΩ or higher |
| I1-3 (+) - Body ground | Always | 10 kΩ or higher |
| I1-1 (-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY |
Resistance check
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J5-1 - J5-2 | Always | 3.2 to 4.8 Ω |
| K5-1 - K5-2 | Always | 3.2 to 4.8 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Front No. 1 Speaker Assembly) |
|
| ||||
| OK | |
| 4.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY |
Resistance check
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I83-2 (TWR-) - I83-4 (TWR+) | Always | 10 kΩ or higher |
| I83-1 (-) - I83-2 (TWR-) | Always | Below 1 Ω |
| I83-3 (+) - I83-4 (TWR+) | Always | Below 1 Ω |
| I1-2 (TWL-) - I1-4 (TWL+) | Always | 10 kΩ or higher |
| I1-1 (-) - I1-2 (TWL-) | Always | Below 1 Ω |
| I1-3 (+) - I1-4 (TWL+) | Always | Below 1 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Front No. 2 Speaker Assembly) |
|
| ||||
| OK | |
| 5.REPLACE FRONT NO. 2 SPEAKER ASSEMBLY |
Check that the malfunction disappears when a known good speaker is installed (Click here).
|
| ||||
| OK | ||
| ||
| 6.INSPECT REAR SPEAKER ASSEMBLY |
Resistance check
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O18-1 - O18-2 | Always | 3.2 to 4.8 Ω |
| O21-1 - O21-2 | Always | 3.2 to 4.8 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Rear Speaker Assembly) |
|
| ||||
| OK | ||
| ||
| 7.CHECK HARNESS AND CONNECTOR |
Disconnect the connectors from the stereo component amplifier assembly and speakers.
Measure the resistance between each of the front No. 1 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I68-15 (FR+) - J5-1 (+) | Always | Below 1 Ω |
| I68-30 (FR-) - J5-2 (-) | Always | Below 1 Ω |
| I68-11 (FL+) - K5-1 (+) | Always | Below 1 Ω |
| I68-26 (FL-) - K5-2 (-) | Always | Below 1 Ω |
Measure the resistance between each of the front No. 2 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I68-12 (TWR+) - I84-4 | Always | Below 1 Ω |
| I68-27 (TWR-) - I84-3 | Always | Below 1 Ω |
| I68-14 (TWL+) - I2-4 | Always | Below 1 Ω |
| I68-29 (TWL-) - I2-3 | Always | Below 1 Ω |
Measure the resistance between the front No. 3 speaker assembly and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I68-13 (CTR+) - I60-2 | Always | Below 1 Ω |
| I68-28 (CTR-) - I60-1 | Always | Below 1 Ω |
Measure the resistance between each of the rear No. 2 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I68-10 (SR+) - O19-2 | Always | Below 1 Ω |
| I68-25 (SR-) - O19-1 | Always | Below 1 Ω |
| I68-9 (SL+) - O20-2 | Always | Below 1 Ω |
| I68-24 (SL-) - O20-1 | Always | Below 1 Ω |
Measure the resistance between the rear speaker assembly and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I68-8 (WF1+) - O22-1 | Always | Below 1 Ω |
| I68-23 (WF1-) - O22-2 | Always | Below 1 Ω |
Measure the resistance between the stereo component amplifier assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
| I68-15 (FR+) - Body ground | Always | 10 kΩ or higher |
| I68-30 (FR-) - Body ground | Always | 10 kΩ or higher |
| I68-11 (FL+) - Body ground | Always | 10 kΩ or higher |
| I68-26 (FL-) - Body ground | Always | 10 kΩ or higher |
| I68-12 (TWR+) - Body ground | Always | 10 kΩ or higher |
| I68-27 (TWR-) - Body ground | Always | 10 kΩ or higher |
| I68-14 (TWL+) - Body ground | Always | 10 kΩ or higher |
| I68-29 (TWL-) - Body ground | Always | 10 kΩ or higher |
| I68-13 (CTR+) - Body ground | Always | 10 kΩ or higher |
| I68-28 (CTR-) - Body ground | Always | 10 kΩ or higher |
| I68-10 (SR+) - Body ground | Always | 10 kΩ or higher |
| I68-25 (SR-) - Body ground | Always | 10 kΩ or higher |
| I68-9 (SL+) - Body ground | Always | 10 kΩ or higher |
| I68-24 (SL-) - Body ground | Always | 10 kΩ or higher |
| I68-8 (WF1+) - Body ground | Always | 10 kΩ or higher |
| I68-23 (WF1-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 8.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J5-1 (+) - J5-2 (-) | Always | 4.6 to 6.6 Ω |
| K5-1 (+) - K5-2 (-) | Always | 4.6 to 6.6 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Front No. 1 Speaker Assembly) |
|
| ||||
| OK | |
| 9.INSPECT FRONT NO. 2 SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I84-4 - I84-3 | Always | 3.4 to 5.2 Ω |
| I2-4 - I2-3 | Always | 3.4 to 5.2 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Front No. 2 Speaker Assembly) |
|
| ||||
| OK | |
| 10.INSPECT FRONT NO. 3 SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I60-2 - I60-1 | Always | 6.8 to 10.2 Ω |
| *a | Component without harness connected (Front No. 3 Speaker Assembly) |
|
| ||||
| OK | |
| 11.INSPECT REAR NO. 2 SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O19-2 - O19-1 | Always | 6.8 to 10.2 Ω |
| O20-2 - O20-1 | Always | 6.8 to 10.2 Ω |
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected (Rear No. 2 Speaker Assembly) |
|
| ||||
| OK | |
| 12.INSPECT REAR SPEAKER ASSEMBLY |
![]() |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O22-1 - O22-2 | Always | 4.8 to 6.8 Ω |
| *a | Component without harness connected (Rear Speaker Assembly) |
|
| ||||
| OK | ||
| ||