AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Radio Broadcast cannot be Received or Poor Reception |
| 1.CHECK RADIO RECEIVER ASSEMBLY |
Check the radio automatic station search function.
Check the radio automatic station search function by activating it.
| Result | Proceed to |
| Automatic station search function does not stop | A |
| Automatic station search function stops on a station | B |
|
| ||||
| A | |
| 2.CHECK OPTIONAL COMPONENTS |
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
| Result | Proceed to |
| Optional components are not installed | A |
| Optional components are installed | B |
|
| ||||
| A | |
| 3.CHECK RADIO RECEIVER ASSEMBLY |
![]() |
Preparation for check
Remove the antenna connector from the radio receiver assembly.
Check for noise
Turn the ignition switch ACC with the radio receiver assembly connector connected.
Turn the radio on and tune into AM mode.
Place a screwdriver, thin wire or other metal object on the radio receiver assembly antenna jack and check that noise can be heard from the speakers.
|
| ||||
| OK | |
| 4.CHECK WINDOW GLASS ANTENNA WIRE |
![]() |
Check for continuity in the window glass antenna wire.
| *a | Tester Probe |
| *b | Antenna Wire |
| *c | Tin Foil |
|
| ||||
| OK | |
| 5.INSPECT RADIO RECEIVER ASSEMBLY |
Disconnect the radio receiver assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| RA-5 (ANT+) - Body ground | Ignition switch ACC Radio switch on and FM or AM selected | 11 to 14 V |
| *a | Component without harness connected (Radio Receiver Assembly) |
|
| ||||
| OK | |
| 6.REPLACE ANTENNA CORD SUB-ASSEMBLY |
Replace the antenna cord sub-assembly and check if radio broadcasts can be received normally (Click here).
|
| ||||
| OK | ||
| ||
| 7.CHECK NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Disconnect the No. 2 antenna cord sub-assembly.
Measure the resistance the No. 2 antenna cord sub-assembly to check for an open circuit in the No. 2 antenna cord sub-assembly.
Measure the resistance between the No. 2 antenna cord sub-assembly and body ground to check for a short circuit in the No. 2 antenna cord sub-assembly.
|
| ||||
| OK | |
| 8.REPLACE AMPLIFIER ANTENNA ASSEMBLY |
Replace the amplifier antenna assembly and check if radio broadcasts can be received normally (Click here).
|
| ||||
| OK | ||
| ||