Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the Techstream to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the Techstream on.

  6. Enter the following menus:

    1. for Combination Meter: Body Electrical / Combination Meter / Data List.

    2. for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List.

    3. for Engine and ECT: Powertrain / Engine / Data List.

    4. for Main Body: Body Electrical / Main Body / Data List.

  7. Check the values by referring to the table below.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ODO/TRIP Change SW
    ODO/TRIP change switch knob/OFF or ON
    OFF: Switch released
    -
    ON: Switch pushed
    -
    P-Seatbelt Buckle SW
    Front passenger seat belt buckle switch/OFF or ON
    OFF: Front passenger seat belt fastened (warning light off)
    -
    ON: Front passenger seat belt unfastened (warning light on)
    Vehicle Speed Meter
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Almost the same as actual vehicle speed
    -
    Engine Rpm
    Engine speed/Min.: 0 rpm, Max.: 12750 rpm
    1. 610 to 710 rpm: Idling (for 2AR-FE)
    2. 600 to 700 rpm: Idling (for 2GR-FE)
    -
    Coolant Temperature
    Engine coolant temperature/-40 to 127.5°C (-40 to 261.5°F)
    After warming up: 75 to 100°C (167 to 212°F)

    HINT:
    1. After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).
    2. After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.
    3. If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
    4. Check if the engine overheats when the value indicates higher than 135°C (275°F).

    Washer Switch
    Washer fluid level warning switch/OFF or ON
    OFF: Washer fluid level not low
    -
    ON: Washer fluid level low
    -
    Light Control Switch
    Display contrast adjust switch/OFF or ON
    OFF: Display contrast adjust switch not pressed
    -
    ON: Display contrast adjust switch pressed
    -
    +B Voltage Value
    Battery voltage/Min.: 0 V, Max.: 25.5 V
    11 to 14 V
    -
    Integrated Value for Oil Maintenance*2
    Maintenance required reminder value/Min.: 0, Max.: 25500 (mile)
    Driving distance after performing maintenance required reminder reset procedure displayed
    If the value is 5000 (miles) or more, perform the maintenance required reminder reset procedure after performing maintenance.
    Fuel Input
    Fuel input/Min.: 0 G, Max. 127.5 G
    Fuel receiver gauge indicates F: 57.0
    Unit: Liter
    Fuel receiver gauge indicates 3/4: 48.3
    Fuel receiver gauge indicates 1/2: 32.2
    Fuel receiver gauge indicates 1/4: 16.1
    Fuel receiver gauge indicates E: 6.4
    Multi Display Select Switch*1
    DISP switch in the steering pad switch assembly/OFF or ON
    OFF: DISP switch in the steering pad switch assembly not pressed
    -
    ON: DISP switch in the steering pad switch assembly pressed
    Ambient Temperature
    Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F)
    Almost the same as actual outside temperature
    The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
    Oil Pressure Switch
    Oil pressure switch/OFF or ON
    OFF: Engine starts
    -
    ON: Engine does not start
    Turn Signal Switch (Right)
    RH turn signal switch/OFF or ON
    OFF: RH turn switch off
    -
    ON: RH turn switch on
    Turn Signal Switch (Left)
    LH turn signal switch/OFF or ON
    OFF: LH turn switch off
    -
    ON: LH turn switch on
    Hazard Flasher Switch
    Hazard warning switch/OFF or ON
    OFF: Switch released
    -
    ON: Switch pushed
    Key Remind Sound
    Cycle of the key reminder warning buzzer
    The cycle of the key reminder warning buzzer/Large, Medium, Small
    -
    Driver Side Seatbelt Warning Buzzer
    Condition of the seat belt warning buzzer/OFF or ON
    OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened
    Displays customize setting of seat belt warning buzzer
    ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened
    P-Seatbelt Warning Buzzer
    Condition of the seat belt warning buzzer/OFF or ON
    OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger seat belt unfastened
    Displays customize setting of seat belt warning buzzer
    ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger seat belt unfastened
    Number of Trouble Code
    The number of the DTC currently stored
    0 to 255
    -

    1. *1: w/ Multi-information Display
    2. *2: with mph units

    ABS/VSC/TRAC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Vehicle stopped: 0 km/h (0 mph)
    When driving at constant speed: No large fluctuations

    Engine and ECT 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Injection Volume (Cylinder 1)
    Injection volume (cylinder 1)/Min.: 0 ml, Max.: 2.047 ml
    0 to 0.5 ml
    1. Stored as Freeze Frame Data
    2. This is the fuel injection volume for 10 injections.
    Results of real-vehicle check:
    1. Idling (engine warmed up): 0.108 ml
    2. Running without load (3000 rpm): 0.097 ml
    Engine Speed
    Engine speed/Min.: 0 rpm, Max.: 16383 rpm
    1. 610 to 710 rpm: Idling (for 2AR-FE)
    2. 600 to 700 rpm: Idling (for 2GR-FE)
    1. Stored as Freeze Frame Data
    2. When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
    Results of real-vehicle check:
    Idling (warm up the engine and A/C off): 660 rpm
    Coolant Temp
    Coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F)
    75 to 100°C (167 to 212°F): After warming up
    1. Stored as Freeze Frame Data
    2. This is the engine coolant temperature.

    HINT:
    1. After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).
    2. After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.
    3. If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.
    4. Check if the engine overheats when the value indicates higher than 135°C (275°F).


    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Illumination Rate Info
    Illumination rate information/0 ms. to 2162.65 ms.
    Value output according to ambient light level
    -


ACTIVE TEST
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  5. Check the operation by referring to the table below.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation
    Speedometer
    0, 40, 80, 120 mph*1
    -
    0, 40, 80, 120, 160, 200, 240 km/h*2
    Tacho Meter Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm)
    -
    Fuel Meter Operation
    Fuel receiver gauge
    EMPTY, 1/2, FULL
    -
    Fuel Consumption Meter Operation
    Fuel consumption meter
    OFF, MIN., 1/4, 1/2, 3/4, MAX.
    -
    A/T Indicator Operation 1
    Shift indicator (P, N. R, 4(M), 3(M), 2, L, D)
    OFF or ON
    -
    A/T Indicator Operation 2
    Shift indicator (Es, M, B, S, 8 7, 6, 5)
    OFF or ON
    -
    A/T Indicator Operation 3
    Shift indicator (D)
    OFF or ON
    -
    Indicat. Lamp Airbag
    SRS warning light
    OFF or ON
    -
    Indicat. Lamp Doors All Open
    Door indicator light
    OFF or ON
    -
    Driver Side Seat Belt
    Seat belt warning light
    OFF or ON
    -
    Indicat. Lamp ABS
    ABS warning light
    OFF or ON
    -
    Indicat. Lamp Charge
    Charge warning light
    OFF or ON
    -
    Indicat. Lamp Slip
    Slip indicator light
    OFF or ON
    -
    Indicat. Lamp Beam
    High beam indicator light
    OFF or ON
    -
    Indicat. Lamp Head*1
    Head indicator light
    OFF or ON
    -
    Indicat. Lamp Tail*2
    Tail indicator light
    OFF or ON
    -
    Indicat. Lamp Fr FOG
    Front fog indicator light
    OFF or ON
    -
    Indicat. Lamp Rr FOG*3
    Rear fog indicator light
    OFF or ON
    *8
    Indicat. Lamp Washer
    Washer fluid level warning light
    OFF or ON
    -
    Indicat. Lamp AFS*4
    AFS (adaptive front-lighting system) warning light
    OFF or ON
    *8
    Indicat. Lamp Fuel
    Fuel level warning light
    OFF or ON
    -
    VSC TRC Indicator
    TRAC OFF or TRC OFF indicator light
    OFF or ON
    -
    Indicat. Tire Pressure Warning System*5
    Tire pressure warning light
    OFF or ON
    -
    Indicat. Oil Pressure
    Oil pressure warning light
    OFF or ON
    -
    Indicat. ECONO
    ECO indicator light
    OFF or ON
    -
    Indicat. Lamp Cruise
    Cruise control indicator light (green)
    OFF or ON
    -
    Indicat. Lamp Brake
    Brake warning light
    OFF or ON
    -
    Indicat. EPS
    EPS warning light
    OFF or ON
    -
    Indicat. Oil Maintenance*1
    Maintenance required reminder light
    OFF or ON
    -
    Master Warning
    Master warning light
    OFF or ON
    -
    Indicat. SET
    SET indicator light
    OFF or ON
    -
    Indicat. VSC OFF
    VSC off indicator light
    OFF or ON
    -
    Cruise Indicator
    Cruise control indicator light (amber)
    OFF or ON
    *9
    Turn Signal (Left) Indicator
    LH turn indicator light
    OFF or ON
    -
    Turn Signal (Right) Indicator
    RH turn indicator light
    OFF or ON
    -
    Smart System Indicator*6
    Smart key system warning light (green)
    OFF or ON
    -
    Smart System Warning*6
    Smart key system warning light (orange)
    OFF or ON
    *10
    Blind Spot Monitor Indicator*7
    Blind spot monitor indicator light
    OFF or ON
    -
    Water temperature meter operation
    Engine coolant temperature receiver gauge
    Low, Normal, High
    -
    Meter Display 1
    Multi-information display
    OFF, 0, 1, 2, 3, 4, 5, 6
    -
    Meter Display 2
    All dots in the ODO/TRIP meter
    OFF, 7, 8, 9
    -

    1. *1: with mph units
    2. *2: with km/h units
    3. *3: w/ Rear Fog Light
    4. *4: w/ AFS (Adaptive Front-lighting System)
    5. *5: w/ Tire Pressure Warning System
    6. *6: w/ Smart Key System
    7. *7: w/ Blind Spot Monitor System
    8. *8: Although the item is displayed on the Techstream, no warning light or indicator light is operated.
    9. *9: The cruise control indicator light (amber) can be operated by selecting this item.
    10. *10: The smart key system warning light (orange) can be operated by selecting this item.