Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Combination Meter, Occupant Detection or SRS Airbag / Data List.

  5. Read the Data List according to the display on the Techstream.

    Combination Meter (Combination Meter Assembly) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Driver Side Seatbelt Warning Buzzer
    Driver seat belt warning buzzer/ON or OFF
    Customized value displayed
    -
    P-Seatbelt Warning Buzzer
    Front passenger seat belt warning buzzer/ON or OFF
    Customized value displayed
    -

    Occupant Detection (Occupant Detection ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Passenger Buckle SW
    Front passenger buckle switch/Set, Unset or NG
    Set: Seat belt fastened
    Unset: Seat belt not fastened
    NG: Data is not determined
    -

    SRS Airbag (Airbag Sensor Assembly) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Left side Buckle SW
    LH buckle switch/Unset, Set or NG
    Unset: Seat belt not fastened
    Set: Seat belt fastened
    NG: Data is not determined
    -
    Right side Buckle SW
    RH buckle switch/Unset, Set or NG
    Unset: Seat belt not fastened
    Set: Seat belt fastened
    NG: Data is not determined
    -


ACTIVE TEST
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  5. Perform the Active Test according to the display on the Techstream.

    Combination Meter (Combination Meter Assembly) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Driver Side Seat Belt
    Seat belt warning light
    OFF/ON
    -