Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door)

POWER WINDOW REGULATOR MOTOR (for Rear Door) > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    B127536E07
  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise

    Text in Illustration 
    *a
    Component without harness connected
    (Power Window Regulator Motor Assembly LH)
    *b
    Motor Gear
    *c
    Clockwise
    *d
    Counterclockwise
    If the result is not as specified, replace the power window regulator motor assembly LH.



2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH


    B127535E03
  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor gear rotates clockwise
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Motor gear rotates counterclockwise

    Text in Illustration 
    *a
    Component without harness connected
    (Power Window Regulator Motor Assembly RH)
    *b
    Motor Gear
    *c
    Counterclockwise
    *d
    Clockwise
    If the result is not as specified, replace the power window regulator motor assembly RH.