THEFT DETERRENT SYSTEM > Unlock Warning Switch Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key Unlock Warning SW | Unlock warning switch/ON or OFF | ON: Key is inserted into ignition key cylinder OFF: Key is removed from ignition key cylinder | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
![]() |
Remove the unlock warning switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Free (Key removed) | 10 kΩ or higher |
| 1 - 2 | Pushed (Key set) | Below 1 Ω |
| *1 | Free (key removed) |
| *2 | Pushed (key set) |
| *a | Component without harness connected (Unlock Warning Switch Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - UNLOCK WARNING SWITCH - BODY GROUND) |
Disconnect the I13 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I13-17 (KSW) - I33-1 | Always | Below 1 Ω |
| I13-17 (KSW) - Body ground | Always | 10 kΩ or higher |
| I33-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||