Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:

    Tire Size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P205/65R16 94S
    240 (2.4, 35)
    P215/55R17 93V
    240 (2.4, 35)*1
    210 (2.1, 30)*2
    P225/45R18 91V
    230 (2.3, 33)

    *1: except Mexico
    *2: for Mexico



    C137874
  1. Using a dial indicator, check the runout of the tires.

    Maximum tire runout:
    1.4 mm (0.0551 in.)



2. ROTATE TIRES


    C197919E02
  1. Rotate the tires as shown in illustration (A). If the vehicle is equipped with a full size spare tire, rotate the tires as shown in illustration (B).
    Text in Illustration 
    V100135
    Front



3. INSPECT AND ADJUST WHEEL BALANCE


  1. Inspect and adjust the off-the-car balance.

    1. Steel wheel:

      Maximum imbalance:
      8.0 g (0.0176 lb)



    2. C144018E06
    3. Others (Non-steel wheel):

      Maximum imbalance:
      8.0 g (0.0176 lb)

      NOTICE:
      1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
      2. Do not touch the adhesive surface of the tape.
      3. Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

        Width (A):
        25 mm (0.984 in.)

      4. Push the balance weight securely with your finger to adhere it to the desired position.
      5. Do not reuse balance weights.

      HINT:
      The inner side balance weight should be installed by clipping it to the rim.



4. INSPECT FRONT AXLE HUB BEARING
(Click here)


5. INSPECT REAR AXLE HUB BEARING
(Click here)