POWER WINDOW CONTROL SYSTEM > OPERATION CHECK |
| CHECK WINDOW LOCK SWITCH |
![]() |
Check that the front passenger and rear windows cannot be operated when the window lock switch of the power window regulator master switch assembly is pushed in.
Check that the front passenger and rear windows can be operated when the window lock switch of the power window regulator master switch assembly is pushed in again.
| CHECK MANUAL UP / DOWN FUNCTION |
Check that the driver door power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Ignition switch ON | Driver door | Pulled halfway up | UP (Closes) |
| Pushed halfway down | DOWN (Opens) |
Check that the front passenger door window and rear power windows operate as follows:
| Condition | Regulator Switch | Switch Operation | Power Window |
| Front passenger door | Pulled up | UP (Closes) |
| Pushed down | DOWN (Opens) | ||
| Rear LH door | Pulled up | UP (Closes) | |
| Pushed down | DOWN (Opens) | ||
| Rear RH door | Pulled up | UP (Closes) | |
| Pushed down | DOWN (Opens) |
| CHECK AUTO UP / DOWN FUNCTION |
Check that the driver door power window operates as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Ignition switch ON | Driver door | Pulled up (One touch operation) | AUTO UP (Closes) |
| Pushed down (One touch operation) | AUTO DOWN (Opens) |
| CHECK REMOTE MANUAL UP / DOWN FUNCTION |
Check that the front passenger door window and rear power windows operate as follows:
| Condition | Master Switch | Switch Operation | Power Window |
| Front passenger door | Pulled up | UP (Closes) |
| Pushed down | DOWN (Opens) | ||
| Rear LH door | Pulled up | UP (Closes) | |
| Pushed down | DOWN (Opens) | ||
| Rear RH door | Pulled up | UP (Closes) | |
| Pushed down | DOWN (Opens) |
| CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF |
Check that all the power windows can be operated with the power widow regulator master switch assembly and power window regulator switch assemblies (for front passenger door, rear LH and RH doors) after the ignition switch is turned off.
Check that the key-off operation function does not operate after the driver door or front passenger door is opened immediately.
Check that all the power windows cannot be operated after more than approximately 43 seconds have elapsed since the ignition switch was turned off.
| CHECK KEY-LINKED FUNCTION USING DRIVER DOOR KEY CYLINDER* |
Check that the driver door power window operates as follows:
| Condition | Door Key Cylinder Operation | Power Window |
| No key is inside vehicle, and all doors are closed | LOCK switch pressed and held for more than 1.5 seconds | UP (Closes) |
| No key is inside vehicle, and all doors are closed | Returned to neutral position | STOP |
| No key is inside vehicle, and all doors are closed | UNLOCK switch pressed and held for more than 1.5 seconds | DOWN (Opens) |
| No key is inside vehicle, and all doors are closed | Returned to neutral position | STOP |
| CHECK WIRELESS TRANSMITTER-LINKED FUNCTION (w/ Daytime Running Light Control)* |
Check that the driver door power window operates as follows when operating the transmitter:
| Condition | Transmitter Operation | Power Window |
| No key is inside vehicle, and all doors are closed and locked | UNLOCK switch pressed for more than 2.4 seconds | DOWN (Opens) |
| No key is inside vehicle, and all doors are closed and locked | UNLOCK switch released | STOP |
| CHECK JAM PROTECTION FUNCTION |
Check the basic function.
Fully open the driver door window.
![]() |
Set a check jig wrapped with a piece of cloth near the window fully closed position.
| *1 | Check Jig |
| *2 | Cloth |
Operate the auto up or manual up function to check that the power window stops and goes down after the check jig is caught between the window and door frame, and stops when the opening reaches approximately 200 mm (7.87 in.) or until approximately 5 seconds elapse.
While the power window is moving down, check that the door glass cannot be raised when the power window switch is used.
| CHECK POWER WINDOW REGULATOR MASTER SWITCH LED ILLUMINATION |
![]() |
Check the LED illumination (power window regulator master switch assembly).
| *1 | LED |
Check that the LED located on the power window regulator master switch assembly illuminates when the ignition switch is turned to ON.