Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 2GR-FE)

COMPRESSOR (for 2GR-FE) > DISASSEMBLY

for Preparation Click here



1. REMOVE COOLER BRACKET


    E231354
  1. Disconnect the connector.

  1. Disengage the clamp.

  1. Remove the screw and cooler bracket.



2. REMOVE MAGNET CLUTCH ASSEMBLY


    E156529E01
  1. Clamp the cooler compressor in a vise between aluminum plates.

  1. Using SST, hold the magnet clutch hub.

    SST
    07112-76060  

  1. Remove the bolt, magnet clutch hub and magnet clutch washer(s).

    HINT:
    There is no set number of magnet clutch washers that are used for adjusting clutch clearance.



    I104018
  1. Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Disengage the clamp.



    I104019
  1. Using a snap ring expander, remove the snap ring and magnet clutch stator.