PARK / NEUTRAL POSITION SWITCH > REMOVAL |
| 1. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 2. REMOVE INLET NO. 2 AIR CLEANER |
![]() |
Disconnect the 2 wire harness clamps and vacuum hose clamp.
Remove the 2 bolts and inlet No. 2 air cleaner.
| 3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the mass air flow meter connector and wire harness clamp.
![]() |
Disconnect the 3 hoses.
Separate the ventilation hose.
![]() |
Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.
Release the 2 clamps and remove the air cleaner cap with hose.
| 4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.
Remove the 2 bolts and air cleaner case sub-assembly.
| 6. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY |
Move the shift lever to N.
![]() |
Disconnect the wire harness clamp.
![]() |
Remove the nut from the control shaft lever.
Remove the clip and disconnect the transmission control cable from the control cable bracket.
| 7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Disconnect the connector from the park/neutral position switch.
![]() |
Remove the nut, washer and control shaft lever from the control shaft.
![]() |
Remove the 2 bolts and park/neutral position switch from the control shaft.