Home › Vehicle Exterior › HORN › HORN

HORN > INSPECTION

for Preparation Click here



1. INSPECT HIGH PITCHED HORN ASSEMBLY (w/ Daytime Running Light)


    E226252E01
  1. Apply battery voltage and check the operation of the horn according to the table below.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal A4-1
    Battery negative (-) → Body ground
    Horn sounds

    Text in Illustration 
    *a
    Component without harness connected
    (High Pitched Horn Assembly)
    If the result is not as specified, replace the high pitched horn assembly.



2. INSPECT LOW PITCHED HORN ASSEMBLY (w/ Daytime Running Light)


    E226253E01
  1. Apply battery voltage and check the operation of the horn according to the table below.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal A1-1
    Battery negative (-) → Body ground
    Horn sounds

    Text in Illustration 
    *a
    Component without harness connected
    (Low Pitched Horn Assembly)
    If the result is not as specified, replace the low pitched horn assembly.



3. INSPECT LOW PITCHED HORN ASSEMBLY (w/o Daytime Running Light)


    E226257E01
  1. Apply battery voltage and check the operation of the horn according to the table below.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal A1-1
    Battery negative (-) → Body ground
    Horn sounds

    Text in Illustration 
    *a
    Component without harness connected
    (Low Pitched Horn Assembly)
    If the result is not as specified, replace the low pitched horn assembly.



4. INSPECT SUPER LOW PITCHED HORN ASSEMBLY (w/o Daytime Running Light)


    E226258E02
  1. Apply battery voltage and check the operation of the horn according to the table below.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal A84-1
    Battery negative (-) → Body ground
    Horn sounds

    Text in Illustration 
    *a
    Component without harness connected
    (Super Low Pitched Horn Assembly)
    If the result is not as specified, replace the super low pitched horn assembly.