HEADLIGHT LEVELING SWITCH > INSPECTION |
| 1. INSPECT HEADLIGHT LEVELING SWITCH |
Voltage Check
![]() |
Connect a positive (+) lead from the battery to terminal 1 (B) and a negative (-) lead to terminal 5 (E).
Measure the voltage according to the value(s) in the table below.
| Tester Condition | Switch Position | Specified Condition (Battery voltage is 12 V) |
| 2 (T) - 5 (E) | 0 | 10.44 to 11.16 V |
| 1 | 9.16 to 9.88 V | |
| 2 | 7.88 to 8.60 V | |
| 3 | 6.6 to 7.32 V | |
| 4 | 5.32 to 6.04 V | |
| 5 | 4.04 to 4.76 V |
| *a | Component without harness connected (Headlight Leveling Switch) |
![]() |
LED Illumination Inspection
Apply battery voltage to the headlight leveling switch and check that the switch illuminates.
| Tester Connection | Specified Condition |
| Battery positive (+) → Terminal 3 (ILL+) Battery negative (-) → Terminal 4 (ILL-) | Illuminates |
| *a | Component without harness connected (Headlight Leveling Switch) |