ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL |
| 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH |
| 2. REMOVE ENGINE UNDER COVER LH |
| 3. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH |
| 4. REMOVE ENGINE UNDER COVER RH |
| 5. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Loosen the 2 cylinder block drain cock plugs.
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Cylinder Block Drain Cock Plug |
| *3 | Radiator Drain Cock Plug | *4 | Air Drain Cock Plug |
| 6. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 7. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.
| 8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
![]() |
Disconnect the 2 engine wire clamps.
Disconnect the engine coolant temperature sensor connector.
![]() |
Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.
| *1 | Ball Joint Lock Nut Wrench |
| *2 | Gasket |
Remove the gasket from the engine coolant temperature sensor.