ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL |
| 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH |
| 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH |
| 3. REMOVE ENGINE UNDER COVER LH |
| 4. REMOVE ENGINE UNDER COVER RH |
| 5. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Radiator Drain Cock Plug |
| 6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.
| 7. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 8. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 9. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
![]() |
Disconnect the engine coolant temperature sensor connector.
![]() |
Remove the 2 bolts and disconnect the wire harness.
![]() |
Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.
| *1 | Ball Joint Lock Nut Wrench |
| *2 | Gasket |
Remove the gasket from the engine coolant temperature sensor.