THROTTLE BODY > REMOVAL |
| 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH |
| 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH |
| 3. REMOVE ENGINE UNDER COVER LH |
| 4. REMOVE ENGINE UNDER COVER RH |
| 5. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.

| *1 | Radiator Cap Sub-assembly | *2 | Radiator Drain Cock Plug |
| 6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.
| 7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the vacuum switching valve assembly from the air cleaner hose.
![]() |
Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.
![]() |
Separate the fuel vapor feed hose from the air cleaner hose.
![]() |
Disconnect the ventilation hose from the cylinder head cover.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
![]() |
Release the 2 clamps and remove the air cleaner cap sub-assembly.
| 8. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY |
![]() |
Disconnect the fuel tube from the clamp.
Disconnect the throttle body connector.
![]() |
Disconnect the water by-pass hose from the throttle with motor body assembly.
Disconnect the No. 2 water by-pass hose from the throttle with motor body assembly.
![]() |
Remove the 4 bolts and throttle with motor body assembly with fuel tube bracket.
![]() |
Remove the bolt and fuel tube bracket.
![]() |
Remove the gasket from the intake manifold.