THROTTLE BODY > ON-VEHICLE INSPECTION |
| 1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY |
Check the throttle control motor operating sound.
Turn the engine switch on (IG).
When depressing the accelerator pedal, check the operating sound of the motor. Make sure that no friction noises are emitted from the motor.
If friction noise exists, replace the throttle with motor body assembly.
Check the throttle position sensor.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine / Data List / Gas Throttle / Throttle Sensor Position.
Depress the accelerator pedal. When the throttle valve is fully open, check that the Throttle Sensor Position value is within the specification.
| Tester Display | Specified Condition |
| Throttle Sensor Position | 60% or more |