Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Clean and degrease the threads of the bolt for the crankshaft position sensor.



    A157503E07
  1. Apply a light coat of engine oil to the O-ring of the sensor.
    Text in Illustration 
    *1
    O-ring



    A192239E06
  1. Apply adhesive to 2 or 3 threads of the bolt.
    Text in Illustration 
    *1
    Adhesive

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

  1. Install the sensor with the bolt.

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }

    NOTICE:
    Make sure that the O-ring is not cracked or does not jump out of position during installation.

  1. Connect the sensor connector.



2. INSPECT FOR OIL LEAK