DTC B15C0 Short in GPS Antenna |
DTC B15C1 Open in GPS Antenna |
| DTC No. | DTC Detection Condition | Trouble Area |
| B15C0 | Current for telephone and GPS antenna assembly is more than malfunction criterion for 10 seconds when engine switch is on (IG). (Short circuit) |
|
| B15C1 | Current for telephone and GPS antenna assembly is less than malfunction criterion for 10 seconds when engine switch is on (IG). (Open circuit) |
| 1.CHECK DTC |
Turn the engine switch off.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG) and wait for 10 seconds.
Turn the Techstream on.
Perform "HEALTH CHECK" and check for current DTCs (Click here).
| Result | Proceed to |
| DTC B15C0 or B15C1 is output | A |
| DTC B15C0 or B15C1 is not output | B |
|
| ||||
| A | |
| 2.INSPECT TELEPHONE AND GPS ANTENNA CORD (NO. 2 FLOOR WIRE) |
![]() |
Disconnect the telephone and GPS antenna cord (No. 2 floor wire) connector from the DCM (Telematics Transceiver).
Disconnect the telephone and GPS antenna cord (No. 2 floor wire) from the telephone and GPS antenna assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O34-2 (GPS1) - O37-1 (GPS2) | Always | Below 1 Ω |
| O34-2a - O37-1a | Always | Below 1 Ω |
| O34-2 (GPS1) - Body ground | Always | 10 kΩ or higher |
| O34-2a - Body ground | Always | 10 kΩ or higher |
| *a | Telephone and GPS Antenna Cord (No. 2 Floor Wire) |
|
| ||||
| OK | |
| 3.REPLACE TELEPHONE AND GPS ANTENNA ASSEMBLY |
Replace the telephone and GPS antenna assembly with a known good one and check if the same problem occurs again (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPLACE DCM (TELEMATICS TRANSCEIVER) |
Replace the DCM (Telematics Transceiver) (Click here).
| NEXT | ||
| ||