LUGGAGE DOOR HINGE TORSION BAR > REMOVAL |
| 1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT |
Remove the luggage compartment floor mat.
| 2. REMOVE SPARE WHEEL COVER ASSEMBLY |
Remove the spare wheel cover assembly.
| 3. REMOVE BAGGAGE HOLDER NET (w/ Partition Net) |
Remove the baggage holder net.
| 4. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Remove the 5 clips.
![]() |
Disengage the 4 clips and remove the rear floor finish plate.
| 5. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
![]() |
Push the 2 pins and remove the 2 No. 1 luggage compartment trim hooks.
| *1 | Pin |
| 6. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH |
![]() |
Remove the clip <A>.
| *1 | Clip <A> |
| *2 | Clip <B> |
Remove the 2 clips <B>.
![]() |
Disengage the fastener and remove the luggage compartment inner trim cover LH.
| 7. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER RH |
![]() |
Remove the clip <A>.
| *1 | Clip <A> |
| *2 | Clip <B> |
Remove the 2 clips <B>.
![]() |
Disengage the fastener and remove the luggage compartment inner trim cover RH.
| 8. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH |
![]() |
Disengage the 4 claws and remove the luggage compartment door hinge cover LH.
| 9. REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH |
| 10. REMOVE LUGGAGE DOOR HINGE TORSION BAR LH |
![]() |
Disengage the hook in the order indicated in the illustration and disconnect the rear seatback lock assembly LH (rear seat lock control cable LH).
![]() |
Put protective tape around the luggage door hinge.
| *1 | Protective Tape |
![]() |
Using SST, disconnect the luggage door hinge torsion bar LH from the luggage door hinge and the left side of the vehicle body as shown in the illustration.
![]() |
Disengage the 2 claws as shown in the illustration.
![]() |
Disconnect the luggage door hinge torsion bar LH from the luggage compartment door torsion bar support as shown in the illustration.
![]() |
Remove the luggage door hinge torsion bar LH from the right side of the vehicle body as shown in the illustration.
| 11. REMOVE LUGGAGE DOOR HINGE TORSION BAR RH |
![]() |
Put protective tape around the luggage door hinge.
| *1 | Protective Tape |
![]() |
Using SST, disconnect the luggage door hinge torsion bar RH from the luggage door hinge and the right side of the vehicle body as shown in the illustration.
![]() |
Disconnect the luggage door hinge torsion bar RH from the luggage compartment door torsion bar support as shown in the illustration.
![]() |
Remove the luggage door hinge torsion bar RH from the left side of the vehicle body as shown in the illustration.
| 12. REMOVE LUGGAGE COMPARTMENT DOOR TORSION BAR SUPPORT |
![]() |
Remove the luggage compartment door torsion bar support as shown in the illustration.