Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for 2AR-FE without Wireless Door Lock)

POWER STEERING SYSTEM (for 2AR-FE without Wireless Door Lock) > FAIL-SAFE CHART

for Preparation Click here


If a problem occurs in the power steering system, the power steering assist will be stopped, locked at a particular point, or decreased simultaneously to protect the system.

DTC No.
DTC Detection Condition
Fail-safe
C1511
C1512
C1513
C1514
C1515
C1516
Torque sensor malfunction
Assist force restricted or power assist stopped
C1517
Torque sensor malfunction
C1524
Motor malfunction
C1531
C1532
Power steering ECU assembly malfunction
C1533
Temperature sensor malfunction in power steering ECU assembly
C1534
EEPROM abnormal
C1535
Steering wheel location data error
C1541
Vehicle speed signal malfunction
Assist force restricted
C1551
IG power source voltage error
Power assist stopped
C1552
PIG power source voltage error
C1553
Overvoltage at IG and PIG terminals
C1554
Power source relay malfunction
C1555
Motor relay malfunction
C1581
ECU malfunction (Assist map number un-writing)
Permission of control assist map
U0100
Lost communication with ECM
Power assist stopped
U0129
Lost communication with brake actuator assembly
Assist force restricted

HINT:
  1. The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept in either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine running.
  2. If the battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the P/S warning light will come on. In such cases, the amount of power assist returns normal when the battery voltage recovers.