REAR BRAKE > DISASSEMBLY |
| 1. REMOVE CYLINDER BOOT |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the rear disc brake piston set ring and cylinder boot from the rear disc brake cylinder assembly.
| *1 | Vinyl Tape |
| 2. REMOVE REAR DISC BRAKE PISTON |
![]() |
Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder.
Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder.
| 3. REMOVE PISTON SEAL |
![]() |
Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the disc brake cylinder.
| *1 | Vinyl Tape |
| 4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP |
| 5. REMOVE REAR DISC BRAKE BLEEDER PLUG |