REMOTE ENGINE STARTER SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
| CHECK DLC3 |
Check the DLC3 (Click here).
| CHECK DIAGNOSTIC FACTOR INDICATION |
To prepare the vehicle for diagnostic mode, connect the diagnostic connectors. The steps are as follows.
Remove the front door scuff plate RH .
Remove the cowl side trim sub-assembly RH .
![]() |
Find and connect the diagnostic connectors (labeled RDIG), located in the passenger cowl area.
Perform the following steps to enter diagnostic mode after connecting the diagnostic connectors.
Turn the engine switch from off to on (IG) and wait more than 3 seconds.
Depress the brake pedal.
The diagnostic mode is entered after the hazard warning lights flash.
The diagnostic mode indicates the causes of the engine stop or failure to start by flashing the hazard warning lights as listed below.
| Engine Stop Factor | Number of Flashes | Order of Priority |
| No abnormal stop in the past | 0 | 0 |
| Engine switch on (ACC or IG) | 1 | 1 |
| Any door is unlocked | 2 | 4 |
| Engine speed is too high or low | 3 | 7 |
| Any door or engine hood is opened | 5 | 2 |
| Shift lever is not in P | 6 | 5 |
| Brake pedal is depressed | 7 | 3 |
| Vehicle speed is abnormal | 8 | 6 |
| Immobiliser collation discrepancy | 9 | 9 |