ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Immobiliser / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key SW | Unlock warning switch signal/ON or OFF | ON: Key in ignition key cylinder OFF: No key in ignition key cylinder | - |
| IG SW | Ignition switch signal/ON or OFF | ON: Ignition switch ON or engine start OFF: Ignition switch ACC or off | - |
| Immobiliser | Immobiliser system status/Set or Unset | Set: No key in ignition key cylinder, or 20 sec. elapsed after turning the ignition switch to on (ACC) or off Unset: Key in ignition key cylinder | - |
| Response | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Frame Error | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Different Serial Number | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Different Encrypt Code | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Abnormal Status | Transponder chip data/NG or OK | NG: Data error OK: Data OK | - |
| Bcc Malfunction | Transponder chip data/NG or OK | NG: Incorrect data being sent OK: Correct data being sent | - |
| Sub Key | Sub key code signal/Reg or Unreg | Reg: Registered sub key code sent Unreg: Unmatching sub key code sent | - |
| Master Key | Master key code signal/Reg or Unreg | Reg: Registered master key code sent Unreg: Unmatching master key code sent | - |
| Transponder S-Code | Number of registered sub key/min. 0, max. 15 | Number of registered sub key | - |
| Transponder M-Code | Number of registered master key/min. 0, max. 15 | Number of registered master key | - |
| +B | Power source/Break or Normal | Break: Power source open Normal: Power source normal | - |
| Antenna Coil Status | Transponder key amplifier coil condition/Normal or Fail | Normal: Antenna coil normal Fail: Antenna coil malfunctioning | - |
| E/G Start Permission | Engine start permission/OK or NG | OK: Engine start permitted NG: Engine start not permitted | - |
| Immobi ECU Comm Spd | Immobiliser ECU communication speed/Unknown, 50bps, 200bps or No Res | Unknown: ECU communication speed unknown 50bps: ECU communication speed 50 bps 200bps: ECU communication speed 200 bps No Res: ECU communication speed no response | - |
| The Number of DTCs | Number of DTCs / Min.: 0, Max.: 255 | Number of stored DTCs | - |
| ACTIVE TEST |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Immobiliser or Main Body / Active Test.
Perform the Active Test according to the display on the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator light | ON/OFF | - |
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator light | OFF/ON | - |