OIL AND OIL FILTER > REPLACEMENT |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil drain plug and drain the oil into a container.
Clean the oil drain plug.
Install the oil drain plug with a new gasket.
| 2. REMOVE OIL FILTER CAP ASSEMBLY |
![]() |
Connect the hose with an inside diameter of 15 mm (0.591 in.) to the pipe.
| *1 | Pipe |
| *2 | Hose |
![]() |
Remove the oil filter drain plug from the oil filter cap.
![]() |
Insert the pipe with the hose into the oil filter cap.
| *1 | Cap |
| *2 | O-ring |
| *3 | Pipe |
![]() |
Make sure that oil is completely drained, and remove the pipe and O-ring.
![]() |
Using SST, remove the oil filter cap.
![]() |
Remove the oil filter element and O-ring from the oil filter cap.
| *1 | Oil Filter Element |
| *2 | Oil Filter Cap |
| *3 | O-ring |
| 3. INSTALL OIL FILTER CAP ASSEMBLY |
Clean the inside of the oil filter cap, threads and O-ring groove.
![]() |
Apply a light coat of engine oil to a new O-ring and install it to the oil filter cap.
| *1 | Oil Filter Element |
| *2 | Oil Filter Cap |
| *3 | O-ring |
Install a new oil filter element to the oil filter cap.
Remove all dirt and foreign matter from the installation surface and the inside of the cap on the engine side.
Apply a light coat of engine oil to the O-ring again and install the oil filter cap.
![]() |
Using SST, install the oil filter cap.
| *a | No Clearance |
![]() |
Apply a light coat of engine oil to a new O-ring and install it to the oil filter cap.
| *1 | O-ring |
Install the oil filter drain plug to the oil filter cap.
| 4. ADD ENGINE OIL |
Add clean engine oil and install the oil filler cap.
| Oil Grade | Oil Viscosity (SAE) |
|
|
| Item | Standard Condition |
| Drain and refill with oil filter change | 6.1 liters (6.4 US qts, 5.4 lmp. qts) |
| Drain and refill without oil filter change | 5.7 liters (6.0 US qts, 5.0 lmp. qts) |
| Dry fill | 6.8 liters (7.2 US qts, 6.0 lmp. qts) |
| 5. INSPECT FOR OIL LEAK |