FRONT DRIVE SHAFT ASSEMBLY (for 2AR-FE) > INSPECTION |
| 1. INSPECT FRONT DRIVE SHAFT ASSEMBLY |
![]() |
Check that there is no excessive play in the radial direction of the outboard joint.
Check that the inboard joint slides smoothly in the thrust direction.
Check that there is no excessive play in the radial direction of the inboard joint.
Check the boots for damage.
![]() |
Check whether the drive shaft dimensions (A) are within the following specifications.
| *A | LH Side |
| *B | RH Side |
| Dimension (A) | |||
| LH Side | 587.4 mm (1.93 ft.) | ||
| RH Side | 906.6 mm (2.97 ft.) |