Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE CARRIER

REAR AXLE CARRIER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    C083014
  1. Remove the bolt and separate the rear flexible hose from the rear shock absorber.

  1. Remove the 2 bolts, and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the rear disc brake caliper from hanging down by the flexible hose.



3. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
  1. Remove the parking brake shoe adjusting hole plug.



4. REMOVE REAR DISC


    C238505E01
  1. Put matchmarks on the rear disc and the rear axle hub.
    Text in Illustration 
    *a
    Matchmark



    C201774
  1. Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.



5. DISCONNECT SKID CONTROL SENSOR WIRE


    C236071
  1. Using a screwdriver, disconnect the connector from the rear speed sensor.

    NOTICE:
    Be careful not to damage the rear speed sensor.



6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    C239050
  1. Remove the 4 bolts and the rear axle hub and bearing assembly from the rear axle carrier sub-assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.



7. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)
(Click here)

HINT:
It is necessary to remove the rear height control sensor sub-assembly when separating the rear No. 2 suspension arm assembly RH.



8. SEPARATE REAR STRUT ROD ASSEMBLY


    C239638E01
  1. Use a jack and wooden block to support the rear axle carrier sub-assembly.
    Text in Illustration 
    *1
    Jack
    *2
    Wooden Block

  1. Remove the bolt and nut, and separate the rear strut rod assembly (rear side) from the rear axle carrier sub-assembly.

    NOTICE:
    When removing the bolt, keep the nut from rotating.



9. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY


    C239073
  1. Remove the bolt and nut, and separate the rear No. 2 suspension arm assembly (outer side) from the rear axle carrier sub-assembly.

    NOTICE:
    When removing the bolt, keep the nut from rotating.



10. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY


    C239074
  1. Remove the bolt and nut, and separate the rear No. 1 suspension arm assembly (outer side) from the rear axle carrier sub-assembly.

    NOTICE:
    When removing the bolt, keep the nut from rotating.



11. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY


    C129156
  1. Remove the 2 bolts, 2 nuts and rear axle carrier sub-assembly from the rear shock absorber.

    NOTICE:
    When removing the nuts, keep the bolts from rotating.