Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Front Floor)

ELECTRICAL KEY OSCILLATOR (for Front Floor) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
  1. Connect the connector.

  1. Install the No. 1 indoor electrical key antenna assembly with the bolt.

    NOTICE:
    Be careful when installing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.

  1. Engage the clamp.



2. INSTALL NO. 4 CONSOLE BOX DUCT (w/ Rear Register Duct)
  1. Engage the claw to install the No. 4 console box duct.



3. INSTALL UPPER CONSOLE BOX SUB-ASSEMBLY
  1. w/ Power Outlet Socket:

    1. Connect the connector.

    2. Engage the clamp.



    B284913
  1. Engage the 4 clips as shown in the illustration.

  1. Install the upper console box sub-assembly with the 2 screws.



4. INSTALL REAR CONSOLE UPPER PANEL SUB-ASSEMBLY
  1. Connect the connector.

  1. w/ Seat Heater System:

    1. Connect the 2 connectors.

  1. Engage the 4 clips and install the rear console upper panel sub-assembly.

  1. Move the shift lever to P.



5. INSTALL FRONT PANEL GARNISH RH
  1. Engage the 3 claws, 2 clips and 8 guides to install the front panel garnish RH.



6. INSTALL FRONT PANEL GARNISH LH
  1. Engage the 3 claws, 2 clips and 8 guides to install the front panel garnish LH.



7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B279871
  1. Turn the shift lever knob sub-assembly clockwise to install the shift lever knob sub-assembly.