Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Front Floor)

ELECTRICAL KEY OSCILLATOR (for Front Floor) > REMOVAL

for Preparation Click here



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B279870
  1. Turn the shift lever knob sub-assembly counterclockwise and remove the shift lever knob sub-assembly.



2. REMOVE FRONT PANEL GARNISH LH


    B279866
  1. Disengage the 3 claws, 2 clips and 8 guides to remove the front panel garnish LH.



3. REMOVE FRONT PANEL GARNISH RH


    B279869
  1. Disengage the 3 claws, 2 clips and 8 guides to remove the front panel garnish RH.



4. REMOVE REAR CONSOLE UPPER PANEL SUB-ASSEMBLY
  1. Move the shift lever to N.



    B279872
  1. Disengage the 4 clips.

  1. w/ Seat heater System:

    1. Disconnect the 2 connectors.

  1. Disconnect the connector and remove the rear console upper panel sub-assembly.



5. REMOVE UPPER CONSOLE BOX SUB-ASSEMBLY


    B284911
  1. Remove the 2 screws.



    B284912
  1. Disengage the 4 clips and remove the upper console box sub-assembly as shown in the illustration.



  1. w/ Power Outlet Socket:



      B278006
    1. Disengage the clamp.

    2. Disconnect the connector to remove the upper console box sub-assembly.



6. REMOVE NO. 4 CONSOLE BOX DUCT (w/ Rear Register Duct)


    B293623
  1. Disengage the claw and remove the No. 4 console box duct.



7. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    B279162
  1. Disengage the clamp.

  1. Remove the bolt.

  1. Disconnect the connector and remove the No. 1 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.